Cut Line Sensor Installation

Cut Line Sensor Installation Steps

• Assemble all necessary components

• Run the cut line sensor cable from the pantograph post back to the setworks cabinet alongside the cables spanning the pantograph post

• Once you can freely move the carriage up and down the track, position the sensor and the flag so that

  1. As the carriage drives into the saw from the load end, the sensor turns on between knee 1 and knee 2, closer to knee 2 

  2. The sensor must stay on as the carriage continues to move through the unload end all the way to the end of the track

  3. The sensor should never turn on while the carriage is in the load area