Carriage Install

This page will walk you through the hydraulic flushing procedure that is required at install, and any other time new hydraulic hoses are run between your setworks HPU and knee valves.

This page will walk you through the proper pantograph cabling method. This is crucial to prevent early cable wear  and electrical issues on your system.

This page will review cleereman supplied HPU's and their features. It will also briefly touch on the cooling fans, and temp/level sensors.

This page will walk you through the removal and insertion of probes into carriage knee cylinders.

This page will walk you through the removal and installation of valves on a carriage knee.

This page will walk you through the placement and wiring for the cut line sensor mounted at the top of the pantograph post.

This page will walk you through the components and placement of the scan frame for scan head mounting in an optimized scanning system. 

This page will walk you through the placement and wiring for the reference switch mounted on the rub rail in an optimized scanning system.

This page will walk you through the installation and wiring for the encoder mounted on the carriage drive shaft in an optimized scanning system. Shotgun style systems with on carriage encoder mounting is also covered.

This page covers best practices for cable runs and wiring in the dispatch cabinet for systems with Cleereman Controls dispatch starters and routing.